Genset Controller >> Synchronising and Load Sharing
Trans-SYNCRO
Information
Auto Start Load Share Unit
Auto start load share unit, Automatic and manual start, Multi genset load sharing , Busbar voltages and frequency measurements, Dead bus sensing, Bus failure detection, Sequential set start, Manual voltage/frequeny adjustment, Equal aging of gensets, Direct/reverse governor and AVR control, Synchroscope, Programmable PLC functions
Specifications :
| Communication interface | USB programming and communication port, CanBus communication with 1939 ECU, CanOpen, Ethernet, RS485 |
| Inputs | 13x Configurable digital, 4x Analogue senders, Magnetic Pickup, Charge Alternator D+(WL) inputs |
| Outputs | Configurable 2x Relays, 7x Transistors, GBR outputs |
| Current Measurement | 3 phases CT inputs for Load Current, 1x CT input for Earth Current |
| Voltage Measurement | 3 phases for Alternator |
| Power Factor Measurement | For 3 phases |
Case :
| Dimensions | 276mm x 189mm x 45mm |
| Panel Cut-Out | 223mm x 162mm |
| Protection | NEMA 4X IP65 at front side |
| Weight | Approximately 0,53Kg |
Ratings :
| DC Battery Supply range | 8 to 32Vdc, max.operating current is 360mA |
| CT Secondary | 5A |
| Sender Measurement | 0 to 1300 ohm, accuracy: 1%FS, resolution: 1 ohm |
| Cabin. Temp. Measuremet | -50 to +100 ºC, accuracy: 1 % FS, resolution: 1 ºC. |
| Operating / Storage Temp. | -20°C to +70°C / -30°C to +80°C |